![]() ![]() ![]() These programs should be stopped before running Fan Control. ⚠ This plugin will not function correctly if Corsair iCUE and the "Corsair Service" service is running. As a result, Fan Control's automatic control-sensor pairing may fail for these devices and the sensor must be paired manually. The minimum pump power is 50% (regardless of the requested power in Fan Control).The following LINK devices are supported: Deviceĭon't see your device listed? Open an issue and provide a USB packet capture. Support for the iCUE LINK Hub was added in v1.5.0. Additionally, the default pump power is 100%. This will write a new safety profile to the device:Īs of v1.4.3, the minimum pump power is 50% (regardless of the requested power in Fan Control) to prevent a "pump failure" state and noise/resonance that may occur due to low pump RPM. ![]() The default safety profile stored on the device may be overridden by setting the FANCONTROL_CORSAIRLINK_HYDRO_ASETEK_PRO_SAFETY_PROFILE_OVERRIDE_ENABLED environment variable to 1 and restarting Fan Control. See instructions (also included in download). Requires driver installation and Windows 10/11 64-bit OS. The LibreHardwareMonitor "PSU (Corsair)" sensor source must be disabled in Fan Control's Sensor Settings. The minimum duty depends on the model: PSU Model When the fan power is set to 1% or higher, control of the fan will be returned to Fan Control. When the fan power is set to 0%, control of the fan will be returned to the PSU allowing zero-RPM operation. Variable pump speed using the device's Quiet, Balanced, and Performance presets based on the control's percent value: Control % Please provide your feedback in issues and discussions. ![]() Support is currently experimental and only available in a pre-release (see Releases). Each control will need to be paired with its corresponding sensor manually and its start/stop values will need to be set manually. The speed ramping in the Commander CORE and CORE XT is too slow for automatic sensor pairing and start/stop detection to function in Fan Control. Review the release notes for each version before selecting one to use and regularly check back for updates. These releases may include device-specific fixes and enhancements. This project is under active development, with frequent Beta releases that address issues and incorporate user feedback. The unofficial CorsairLink plugin for Fan Control. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |